PALL RC861CZ090ZYM Differential Pressure Switch

PALL SKU: P-PA-P-1531

$200.00

Tax included

Only 5 left!

Maximum Acceptable Working Pressure:

6000 psi (414 bar)

Temperature Range:

-45®F to 275®F (-43®C to 135®C)

Rated Fatigue Pressure

107 cycles per NF PAT.2.6.1-1974:
3000 psi (207 bar)

Seals:

Internal: Fluorocarbon
External: Nitrile or Fluorocarbon

Housing Material:

Aluminum (Stainless Steel or Other Materials Available)

Electrical Switch Ratings:

4 amp @ 110 VAC, 28 VDC (resistive)
2 amp @ 110 VAC, 28 VDC (inductive)
SPDT, automatic reset

Electrical Switch Circuit:



Installation:

Deltadyne switches and indicators fit Pall housings that have a threaded differential pressure port. A mounting block is available for remote installation.

 


Product Options

 

 

Deltadyne® Switches and Indicators

 

Electrical Switches

Deltadyne® electrical switches have an automatic reset function that allows them to be used as system warm-up monitors. High fluid viscosity associated with low temperature start-ups will cause a higher pressure drop across the filter element. Deltadyne switches will signal high differential pressure until the system reaches operating temperature. As the system warms up, the differential pressure is reduced, and the range spring returns the piston assembly to its normal position, thus restoring the magnetic force between the magnet and the actuator lever. The restored magnetic force is sufficient to overcome the switch spring force, allowing the single pole double throw switch (SPDT) to signal a differential pressure below the switch setting.

Single Pole Double Throw Switch:

The SPDT switch allows this device to be used in a typical green-red light circuit. When the green light signals pressure drops below the actuation pressure, there is element life remaining. The red-light signals pressure drops above the preset value... either a cold start or the need for an element change. The two-light circuit also serves as a continuity check; one of the two lights should always be on.